Vocopro DA-3700 Manuel d'utilisateur télécharger pdf (Page 10)

Vocals

The MIC INSERT jacks on the rear panel allow you to

loop the vocals through an effects unit. NOTE: In or-

der to do this you must have a 1/4” Y adapter cable

(not included) for each microphone line.

Connect the single end of the Y cable into the MIC

INSERT jack. Connect one side of the double end into

the input on the effects device and the other end into

the output of the effects device.

NOTE: If the Y cable is plugged into the DA-3700PRO

but the double ends are not connected to the IN and

OUT of a device, there will be no sound. So if you are

not using effects, be sure the Y cable is unplugged.

Using a mic cable with a 1/4” end, connect the mic

to either of the DA-3700PRO’s microphone inputs.

Effects Loop connections

Source Music (Music from a DVD or CD player)

By using the built-in Effects Loop you can add ef-

fects such as a professional Digital Key Controller

to the source player’s music without compromising

the quality of the original signal. To use the effects

loop connect an RCA cable from the DA-3700PRO’s

EFFECTS LOOP L or R OUT jack to the effects unit

input. Then connect an RCA cable from the effects

unit output, into the DA-3700’s L or R IN jack.

Connect the Remote Key Control cable into the KEY CONTROLLER jack on

the rear panel of the DA-3700PRO.

Mic(s) connection

A mic with Remote Key Control

Getting connected (cont.)

Vovopro DKC-100

To INTo OUT

Vocopro VSPM-1

NOTE: If you are not using the Effects Loop,

be sure the LOOP BARS are re-connected.

Without these, there will be no sound.

Y Adapter Cable

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Vocopro DA-3700 Manuel d'utilisateur Page 10