Vocopro Club-8000 Manuel d'utilisateur télécharger pdf (Page 2)

Setting up the speakers and speaker stands

1. Setup each SS-88 speaker stand by extending the support

legs to a position that is stable and tighten the tension mecha

nism ﬁrmly.

2. Place a VX-15 speaker on top of the SS-88 so that the

shaft of the SS-88 ﬁts ﬂush into the mounting cavity on the

bottom of the VX-15.

NOTE: Each end of the SS-88 pole has a particular diameter

ﬁtted for common speakers’ mounting cavities. If the SS-88

shaft does NOT ﬁt ﬂush into the mounting cavity on the VX-15,

loosen the SS-88 pole and reverse it in the stand and then

remount the speaker.

3. Repeat the above steps for each speaker and stand.

Connecting Power

Be sure that each product has a power cord ﬁrmly attached. It is recommended that you use a power strip/surge protector

when connecting your CLUB-8000 to a power outlet.

Connecting the components

Once you have mounted all of the components into the CLUB-8, it is time to connect them. Follow these directions on con-

necting the components.

NOTE: If you are also connecting components that are not part of the CLUB-8000 system, please refer to the manual of that

product for setup instructions.

MAKE SURE ALL PRODUCTS ARE POWERED OFF

PRIOR TO CONNECTING TO AN AC OUTLET

VX-15 Speaker

SS-88 Stand

CDG-9000 PRO remote unit to the player unit

Connect the Control Interface Connector from “CONNECT TO MAIN UNIT” jack on the rear panel of the remote unit to the

“CONNECT TO REMOTE CONTROLLER” jack on the rear panel of the player unit.

CDG-9000 PRO Controller

CDG-9000 PRO Player

1 1/4”

1 3/4”

1 2 3 4

Pas de commentaire

Vocopro Club-8000 Manuel d'utilisateur Page 2